Rugged Solutions 616-951-5338 info@getruggedsolutions.com
Service · Machine software & PLC programming

Same machine, new software: +90% output.

When an OEM machine is the bottleneck, the limit is often its software, not its steel. We program and rewrite PLC, HMI and PC-side machine software, and coordinate cells of robots, vision and CNCs.

Talk about your machine
+90% OUTPUT 1,500 → 2,900 packages / hour — same machine, new software

“After Rugged Solutions rewrote our OEM machine software, we increased output by 90% from 1500 packages/hour to 2900 packages/hr. The machine's speed now makes the rest of the line equipment the bottleneck.”

Shawn K. Plant Engineer, Our Daily Bread

What we do

OEM machine rewrites

Rework motion sequences, handshakes and timing on machines the original builder no longer supports or can't speed up.

PLC & HMI programming

New logic and operator screens for machines and cells — mainly Allen-Bradley, plus Beckhoff, Delta, AutomationDirect, PLCnext, CODESYS, Ignition and LabVIEW. Other or proprietary systems? Worth a look.

Cell coordination

Robots, vision and CNCs working as one cell: barcode scans, host messages and PLC state routed to the right program.

Line retrofits

Allen-Bradley PLC and HMI, two FANUC R-2000 robots and a Keyence vision system on a heavy-duty floor-tile line.

PC-side & embedded

.NET and embedded firmware where a PLC alone isn't enough — data logging, instruments, custom electronics.

Documented handover

Commented code, drawings and training, so your maintenance team owns the machine afterwards.

How a rewrite runs

  • Measure the real cycle: where the machine waits, and why.
  • Rewrite offline against the existing I/O map and a simulation of the machine.
  • Cut over in a planned window with the old program ready to restore.
  • Prove it with before/after counts from the machine itself.
CNC cell coordinator software combining barcode, host and PLC state
CNC cell coordinator — barcode scans, host communication and PLC state feed the right program.
CUSTOM MACHINES Unique software solutions

“Tom is a team player who provides unique software solutions. His extensive knowledge and experience are valuable resources on our custom automation projects and machines.”

Mike T. Engineering Manager, Criterion Manufacturing Solutions

Related

Machine holding back the line? Let's look at its program.

Book 30 minutes

Questions

Can you change the software on a machine from another builder?
Yes. We regularly take over machines whose original builder is gone, unresponsive or can't make them faster, and we document the result so you aren't locked in again.
Do you work on-site or remotely?
Both. Most programming and simulation is done remotely; we come on-site for measurement, cutover and commissioning anywhere in the United States.