Tests we build
- Electrical safety — HiPot, continuity and insulation testing, including UL962A compliance
- Functional testing — power-up, sensor and actuator checks on multi-circuit assemblies
- Dynamometer — chassis dyno control and SAE J2264 road-load derivation
- In-line inspection — vision and measurement steps inside an assembly sequence
- Fixtures, electronics and software — we design and build the test fixtures and electronics, not just the program
What every station does
- Scans the part and loads the right test automatically
- Shows a live socket / circuit map so operators see what failed, not just that it failed
- Stores every measurement against the serial, searchable for years
- Reports pass/fail and yield to the same OEE dashboards as the rest of the line

Industries
Automotive and tier-1 testing, electrical appliances, aerospace, medical and general manufacturing.
1970s → nowUL962A tester replaced
1990s → nowDyno control modernized
LabVIEWCLAD (past credential)
Projects
Test stand older than your engineers? We replace those.
Book 30 minutesQuestions
Can you replace an old tester without re-validating everything from scratch?
We start by capturing what the existing tester actually does, then reproduce and document those test steps on the new system so results can be compared side by side before cutover.
Do test results connect to production reporting?
Yes. Every result is stored against the part serial and rolls up into the same OEE and yield dashboards as the rest of the line.